Initial Setup
Place the Chummie bedwetting alarm unit on the bedside or someplace convenient where your child can hear the alarm and reach it to turn it off.
Insert the IntelliFlex mat into the cloth sleeve that is provided with the Chummie alarm system.
Place the bed sheet directly over the mat. Ensure that your child does not come in contact with the mat. The mat is sensitive and sweat from the body can trigger the Chummie alarm.
Insert the IntelliFlex mat into the cloth sleeve that is provided with the Chummie alarm system.
Place the bed sheet directly over the mat. Ensure that your child does not come in contact with the mat. The mat is sensitive and sweat from the body can trigger the Chummie alarm.
Alarm Adjustment
To prevent your child from becoming accustomed to any one alarm, Chummie offers you 8 alarm tones, 2 volume levels and vibration control.
Disconnect the mat from the alarm unit by removing the sensor plug from the sensor jack.
Briefly press the enable button. The alarm unit will beep once and activate the program switch for 10 seconds. Changes to the alarm can be now be made.
Select alarm tones by pressing the program switch inwards. There are 8 tones to choose from. The 9th tone is silent mode – vibration and lights only.
Increase or decrease volume by alternately pushing the program switch upwards. Low volume is approximately half as loud as high volume.
Enable or disable vibration by alternately pushing the program switch downwards.
The alarm unit will enter standby (power save) mode 10 seconds after the last adjustment is made with the program switch. In standby mode, the program switch is disabled. To select a new alarm, repeat the steps above.
To prevent your child from becoming accustomed to any one alarm, Chummie offers you 8 alarm tones, 2 volume levels and vibration control.
Disconnect the mat from the alarm unit by removing the sensor plug from the sensor jack.
Briefly press the enable button. The alarm unit will beep once and activate the program switch for 10 seconds. Changes to the alarm can be now be made.
Select alarm tones by pressing the program switch inwards. There are 8 tones to choose from. The 9th tone is silent mode – vibration and lights only.
Increase or decrease volume by alternately pushing the program switch upwards. Low volume is approximately half as loud as high volume.
Enable or disable vibration by alternately pushing the program switch downwards.
The alarm unit will enter standby (power save) mode 10 seconds after the last adjustment is made with the program switch. In standby mode, the program switch is disabled. To select a new alarm, repeat the steps above.